Appendix B.Theory Of Operation

A vibrating wire attached to the surface of a deforming body will deform in a manner similar to that of the deforming body. These deformations alter the tension of the wire, which alters its natural frequency of vibration (resonance).

The relationship between frequency (period) and deformation (strain) is described as follows:

1.The fundamental frequency (resonant frequency) of vibration of a wire is related to its tension, length, and mass. The fundamental frequency may be determined by the equation:

Fundamental_Frequency.png 

Where:

Lw is the length of the wire in inches.

F is the wire tension in pounds.

m is the mass of the wire per unit length (pounds, seconds2/inches2).

2.Note that:

m =

W

Lwg

Where:

W is the weight of Lw inches of wire in pounds.

g is the acceleration of gravity (386 inches/seconds2).

3.And:

 

W = ρaLw          

 

Where:

ρ is the wire material density (0.283 pounds/inches3).

a is the cross-sectional area of the wire in inches2.

4.Combining the equations from steps one, two, and three gives:

Frequency_Calc.png 

5.Note that the tension (F) can be expressed in terms of strain, e.g.,

Tension.png 

Where:

Ɛw is the wire strain (inches/inches).

E is the Young’s modulus of the wire (30 x 106 Psi).

6.Combining the equations from steps four and five gives:

Tension_Calc.png 

7.Substituting the given values for E, g, and ρ yields:

Tension_Substitution.png 

8.In position A, (which displays the period of vibration, T) multiplied by a factor of 106:

Position_A.png 

9.Combining the equations from steps seven and eight gives:

Position_A_Calc.png 

10.The equation from the previous step must now be expressed in terms of the strain in the surface of the body to which the gauge is attached. Since the deformation of the body must equal the deformation of the wire:

Strain.png 

Where:

Ɛ is the strain in the body.

Lg is the gauge length in inches.

11.Combining the equations from steps nine and ten gives:

Strain_Calculation_Epsilon.png 

Where: (for the 4100/4150 strain gauge)

Lw is 2.000 inches

Lg is 2.000 inches

12.Therefore:   

Second_Strain_Calculation_4100.png 

13.The display on position "E" of the readout is based on the equation:

Position_D_4000.png 

The squaring, inverting, and multiplication by the factor 0.391 x 109 is all done internally by the microprocessor of the readout, so that the displayed reading in position C is given in microinches per inch (Ɛ).


Note:    In the previous two steps, T is in seconds x 106 and Ɛ is in microinches per inch.

Alternatively:

Ɛ = 0.391 x 10-3 f 2 micro strain, where f is the frequency in Hz.